[Avila] loading build from cdrom on GW2348-4

[Ahmet Basagalar]

David,

I had the same problem when I received the board. At the final line on 
redboot you should use exec not go, then everything works fine. You can pass 
any kernel line parameters with exec as well.

Regards,
Ahmet
----- Original Message ----- 
From: "David Acker" <dacker at roinet.com>
To: "Avila" <avila at lists.unixstudios.net>
Sent: Monday, September 25, 2006 8:34 AM
Subject: [Avila] loading build from cdrom on GW2348-4
Subject: [Avila] >I have recently received a GW2348-4 system.  I installed the compilers that 
>came on the cd and have done a build in the snapgear directory.  I have 
>tried to run the resulting images but get an error on statup about the 
>board type.  I used the commands from the 
>snapgear/Documentation/INTEL-IXDP425-HOWTO .  I didn't like the errors 
>about the bad addresses but I wasn't sure what I should use instead. Any 
>help folks have would be much appreciated.
> -Dave Acker
>
> RedBoot> load -r -v -b 0x11600000 zImage
> Using default protocol (TFTP)
> Specified address (0x11600000) is not believed to be in RAM - continue 
> (y/n)? y
> \
> Raw file loaded 0x11600000-0x11736567, assumed entry at 0x11600000
> RedBoot> load -r -v -b 0x10800000 ramdisk.gz
> Using default protocol (TFTP)
> Specified address (0x10800000) is not believed to be in RAM - continue 
> (y/n)? y
> -
> Raw file loaded 0x10800000-0x10b17195, assumed entry at 0x10800000
> RedBoot> go 0x11600000
> Uncompressing 
> Linux...................................................................................
> Error: unrecognized/unsupported machine ID (r1 = 0x00000001).
>
> Available machine support:
>
> ID (hex)        NAME
> 000000f5        Intel IXDP425 Development Platform
>
> Please check your kernel config and/or bootloader.
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: avila-unsubscribe at lists.unixstudios.net
> For additional commands, e-mail: avila-help at lists.unixstudios.net
>
>