[Avila] loading build from cdrom on GW2348-4

[dave.hunt at tecnomen.com]

I use the following commands to load the images via tftp:

-----Original Message-----
From: David Acker [mailto:dacker at roinet.com] 
Sent: 25 September 2006 15:35
To: Avila
Subject: [Avila] loading build from cdrom on GW2348-4
Subject: [Avila] I have recently received a GW2348-4 system.  I installed the compilers 
that came on the cd and have done a build in the snapgear directory.  I 
have tried to run the resulting images but get an error on statup about 
the board type.  I used the commands from the 
snapgear/Documentation/INTEL-IXDP425-HOWTO .  I didn't like the errors 
about the bad addresses but I wasn't sure what I should use instead. 
Any help folks have would be much appreciated.
-Dave Acker

RedBoot> load -r -v -b 0x11600000 zImage
Using default protocol (TFTP)
Specified address (0x11600000) is not believed to be in RAM - continue 
(y/n)? y
\
Raw file loaded 0x11600000-0x11736567, assumed entry at 0x11600000
RedBoot> load -r -v -b 0x10800000 ramdisk.gz
Using default protocol (TFTP)
Specified address (0x10800000) is not believed to be in RAM - continue 
(y/n)? y
-
Raw file loaded 0x10800000-0x10b17195, assumed entry at 0x10800000
RedBoot> go 0x11600000
Uncompressing 
Linux.......................................................................
............
Error: unrecognized/unsupported machine ID (r1 = 0x00000001).

Available machine support:

ID (hex)        NAME
000000f5        Intel IXDP425 Development Platform

Please check your kernel config and/or bootloader.

---------------------------------------------------------------------
To unsubscribe, e-mail: avila-unsubscribe at lists.unixstudios.net
For additional commands, e-mail: avila-help at lists.unixstudios.net